Pour on Gloss

Pour on gloss logo

"It is like a liquid glass"

POUR on GLOSS is a two component plastic resin which can be poured over a rough or level surface to provide a crystal clear finish which sets to a hard, strong, non-brittle, glossy coating.
POUR on GLOSS will provide a remarkable finish equal to 50 coats of traditional varnish in a single application.


More information

Doing Decoupage is a breeze by gluing photos & other graphics on a surface with a glue stick, spray on adhesive or water based glue & left until thoroughly dry. They should be sealed with a thin coat of a clear water based sealer & leave until thoroughly dry, before coating in POUR on GLOSS. Metal items, shells, bugs & other keepsakes can be attached using a small amount of quick set glue. No matter how thick the POUR on GLOSS, it remains crystal clear.

It can be Post Cured to with stand surface temperatures of 80-85C & therefore prevent marks from hot coffee cups, etc. POUR on GLOSS is not recommended for outdoor use unless it is sealed with AQUACOTE Polyurethane Clear finish which has excellent UV qualities and is extremely tough.
NOTE: It will not have the same high intensity or high gloss if AQUACOTED

POUR on GLOSS is impervious to water and most household liquids and chemicals including Red Wine when fully cured. Spills on POUR on GLOSS can be cleaned up with a soft cloth or sponge, soap and water.

Pour On Gloss will gel in a few hours, however it will not be hard enough to handle for perhaps 24 hours and even then only with care. After about 3 days, it will become quite hard and able to withstand normal handling. The colder the climate the longer it will take to Gel & set to full strength. If low air temperatures are present heat the work area to above 15oC until the POUR on GLOSS is fully cured.

POUR on GLOSS is safe and easy to use if used in accordance with the instructions. POUR on GLOSS comes with detailed instruction with tips to help you achieve a professional finish, as it provides tips that will save you mistakes.

If the outcome is not quite what you wanted, then sand the POUR on GLOSS with coarse sand paper (80 grit) ensuring all gloss is removed. Dust the surface carefully, using a clean, damp rag to remove any residual dust and pour another coat.


Coverage for a pour coat between 1 and 1.5 mm thick will be:
>    250ml Kit      0.2-0.25 sq. mtr.
>   500ml Kit       0.3-0.5 sq. mtr.
>   1Ltr Kit           0.7-1.0 sq. mtr.

Comes in Kit sizes from 250ml to 40 liters.

Ideas for use

Great for Bringing out the best in Burls
Folk art
Magazine and newspaper clippings
Ceramic Statues
General Coatings
Table and Bar tops

Pour on GlossProjects

Call us to discuss and order or Click Here to go to the online store.